Skip to content
Welder performing a pipe weld on an oil platform over Maracaibo Lake

Oilfield services

Welding, Fabrication & Surface Facilities

Code-qualified welding and construction of surface facilities: fabrication, repair, assembly and dismantling.

  • Afloat & onshore
  • ASME / API qualified procedures

Scope of work

We offer two types of work: new fabrication, built from raw stock to an approved drawing, and repair or replacement of existing installations with certified commercial material. Cutting, dismantling and cleaning services complete the offering. Every job runs with a basic crew of 2 welders and 2 helpers, a portable diesel welding machine, oxy-fuel cutting equipment and a compressor.

RG Marine welding crew with a portable diesel welding machine on deck

AFabrication of new parts & components

Wells & equipment
Wellhead protectors; anti-theft guards for wellheads, valves and equipment; skids for chemical pumps and slickline units; lubricator supports; baskets and lifting structures.
Platforms & structures
New handrails, stairs, walkways and gratings; fenders and berths; pipe supports; new bracing and reinforcements.
Stations & locations
Small tanks, containment boxes and drip trays; stacks, vents and flares; fences, gates and steel sheds.
Custom piping
Spools and nipples; clamps for subsea line repair (diver installed).
Workshop
Steel parts and structures to order.

Requirements

Client-approved drawing, material take-off, workshop, dimensional control and anticorrosive protection.

BRepair & replacement with commercial material

Lines & piping
Leak repair with section replacement; type A and B reinforcement sleeves; gas lift lines; discharge lines at stations and manifolds; welding and installation of flanges, elbows, tees, reducers and valves.
Platforms
Repair of existing handrails, stairs, walkways and gratings; bracing and supports over water; replacement of welded anodes over water.
Wells & equipment
Pumpjack bases and structures; casing extensions and weldable wellheads, per qualified and manufacturer procedures.
Tanks & surface equipment
Tank patches, nozzles and stairs; out-of-service separators and scrubbers; existing stacks, vents and flares.

Requirements

Prior inspection (thickness, failure location), qualified WPS, hot-work permit, certified material and, where applicable, NDT and hydrostatic testing.

CDismantling, cutting & debris removal

  • Cutting and dismantling of out-of-service structures, equipment and lines
  • Cutting of piles and pipes over water
  • Air-arc gouging to remove defective welds
  • Surface cleaning and preparation (pneumatic tools or blasting)
  • Line blowing and drying
  • Scrap recovery and transfer to the client's yard

Plan your next well intervention with us

Combine services under a single contract and a single point of contact.

info@rgmarinegroup.com/+58 414 3618023